![]() |
|||
Home: Baldwin Piano And Organ Company Wurlitzer Grandfather Clock
Data about baldwin piano and organ company wurlitzer grandfather clock* Longcase clocks work well only provided they stand on a flat surface. This sounds easy but it is also very important. When setting it in front of the wall you might perhaps notice that the rug or surfacing is uneven. Or it is possible that the the floor is not uniform at the wall junction. If the case leans and does not stand vertical you will have to compensate for it. * Longcase Clock Pendulums have a distinct front side. The front side most often is the the flat highly polished side. The pendulum and bob swing without touching any part of the case. If it brushes against the case maybe it means that the case stands at an angle. * The weights that supply power to the clock should be free of the pendulum. They should collide with the pendulum or the sides of the clock casing as they come down. * When you get the pendulum going check it out for a steady ticking sound. The sound should be occuring regularly. If the sound is not regular that could be because there are problems with the surface on which the clock stands. Do some experimentation and readjust as needed. * When you adjust the time avoid turning the clock hands towards the back more than just a few minutes. Dont ever turn them back beyond the number twelve. You can safely run the hands of the clock forward. When moving over the twelve mark hold on until the clock is through with sounding the hour chime before you go on. * If your antique clock runs too slow shift the linear dimensions of the pendulum. Make it longer to pare down the speed of the clock. Decrease the pendulum length to to speed up the clock. If you need assistance to set up the longcase clock ask the dealer to help you. Bask In the air of magnificence the grandfather clock adds to your house!
You can get access to a lucrative freelance career for as little as $2.95. Click here for more info and to start immediately
| |||